More Frame Damage,..and Bear!

Here is a photo of the fabric that covered the blog chair's seat.  Notice the deep cut out of the fabric just behind Bear’s tail and on the opposite side in front of his wet nose.  

Photo: SHS

These cuts are made to allow the fabric to go around the arms posts. It is probable that a pattern was made for the the seat fabric when it was first manufactured at the factory. As later upholsterers recovered the seat, these cuts were more likely made during the process of applying the fabric. An astute upholsterer would use the old fabric as a pattern after discerning if its application was accurate. 

Here is a picture of the arm post around which the cutout of the fabric was placed. The majority of the padding that covers the seat is a natural unbleached cotton batting. it is off white and contains tiny dark brown bits of the cotton seed hull. Notice the whiter  filling closest to and surrounding the post.

Photo: SHS

This is a Dacron like substitute for cotton and curled hair. It is similar to the fill inside most contemporary pillows. Any type of fill will compacts over years of use. When the most recent upholsterer recovered the seat, the Dacron was used to fill in the space around the post that had worn down. It is likely the most recent addition to the padding of the chair seat.  It follows that is is probable that the chair seat was not rebuilt by the most recent upholsterer. 

Recall the photo of the long 5/8" staples in yesterday’s blog. 

Photo: SHS

Here is a photo of their removal.  

Photo: SHS

Notice that the pliers grip the fabric. I pull the fabric away from the frame at an angle perpendicular to it. The staples are applied at the same angle.  By removing the staples at the same angle at which they were installed, less wood is taken out with them thereby minimizing damage to the frame. Notice the staples are clean and no shards of wood attached to them. 

The good news is that the 5/8” long staples were not used around the entire perimeter of the chair. 1/2” staples were used around the rest. The 5/8” long staples  were only used on the left side chair rail as you face it.  We call that LSF, or left side facing.  Bad news is that is my clue that the wood on the LSF rail is probably very dry and in poor condition. Longer staples are usually employed to compensate for this condition.  I hope it is not dry rotted. 

Bear would say this frame has had it.....ruff! (:

Theresa

Yummy Furniture and Design

theresamhs@sbcglobal.net

Connect with me at Facebook 
Link up at LinkedIn

For more on the wood's qualities and how people crafted in the medium, see John T. Kirk's, American Furniture, Understanding Styles, Construction and Quality, New York, Harry N. Abrams. Section 2, pp 17-25.